Kia Carens: Fuel Delivery System / Filler-Neck Assembly Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Repair procedures

Removal

1.	Remove the fuel filler neck assembly after unscrewing the mounting bolts (A).

2.	Lift the vehicle.

3.	Remove the left - rear wheel & tire and the wheel house.

4.	Disconnect the fuel filler hose (A), the leveling hose (B) and the ventilation hose (C).

5.	Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (D).

Installation

Install in the reverse order of removal.

Filler-neck assembly installation bolt:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Filler-neck assembly bracket installation bolt:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Fuel Line Repair procedures

Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”) 2 ...

Accelerator Pedal Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sens ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Front Lower Arm Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque: 88.2 ~ ...

Kia Carens RP (2013-2018) Service Manual: Injector Troubleshooting

Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from th ...