Kia Carens: Automatic Transaxle Control System / Shift Lever Repair procedures

Kia Carens RP (2013-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever Repair procedures

Removal
1.
Remove the floor console assembly.
(Refer to Body “Floor Console”)
2.
Disconnect the control cable (A).

3.
Disconnect the wire mounting clips (B).
4.
Disconnect the connector (A).

5.
Remove the bolts and then shift lever assembly (A).
Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kf.m, 6.5 ~ 10.1 lb-ft)

Installation
1.
Install in the reverse order of removal.
  
Check that the shift lever and manual control lever are placed in the "N" position.
Shift Lever Components and components location
Components 1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Retainer ...

Shift Cable Components and components location
Components 1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Retainer ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Repair procedures


Refrigerant System Service Basics (R-134a) Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system.    ...

Kia Carens RP (2013-2018) Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting


Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

Copyright © www.kicaman.com 2015-2025