Kia Carens: ISG (Idle Stop & Go) System / Troubleshooting
If ISG function is not operated, check the related DTC codes. (Refer to DTC
guide.)
If the ISG function is not operated in spite of no DTC, inspect the ISG system
as below.
The GDS tool shows the current data about the ISG function for inspection.
[Battery sensor and calibration value inspection]
[Battery status inspection]
Description
Idle Stop & Go (ISG) function automatically switches off the engine when the
car is at a standstill and the clutch is not operated and starts it again as
soon as ...
Inspection
1.
Remove the ISG switch from the switch assembly.
2.
Check the continuity between the switch 5 and 12 terminals as the ISG
...
Other information:
Special Service Tools
Tool (Number and name)
Illustration
Use
Alternator pulley remover wrench
(09373-27000)
Removal and installation of alternator pulley
...
1. Raise the wiper arm and pull out the wiper blade assembly.
2. Install the new blade assembly by inserting the center part into the slot
in the wiper arm until it clicks into place.
3. Make sure the blade assembly is installed firmly by trying to pull it slightly.
To prevent damage to the wiper ...