Kia Carens: Lighting System / Room Lamp Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Lighting System / Room Lamp Repair procedures

Inspection
1.
Check that the switch operates properly after disconnecting the room lamp connector (A).
Room Lamp

Personal Lamp

[LH]

[RH]

Removal
Room Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver.

3.
Separate the room lamp (A) from the roof trim after loosening the screws (2EA).

4.
Remove the room lamp (B) after disconnecting the connector (A).

5.
If it is necessary to replace the bulb, replace the bulb (A) after detching the lamp lens.

Vanity Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the vanity lamp assembly (A).

3.
Remove the vanity lamp assembly (B) after disconnecting the connector (A).

4.
If it is necessary to replace the bulb, replace the bulb (A).

Personal Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the personal lamp assembly (B) after disconnect the connetor (A).

Installation
Room Lamp
1.
Install the room lamp assembly after connecting the lamp connector.
2.
Install the lens after assembling the bulb.
Personal Lamp
1.
Install the personal lamp assembly after connecting the lamp connector.
Vanity Lamp
1.
Install the vanity lamp assembly after connecting the lamp connector.
Turn Signal Lamp Repair procedures
Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror holder (A) from the outsi ...

Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map l ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Center Fascia Panel Repair procedures


Replacement    • Put on gloves to protect your hands.    • When ...

Kia Carens RP (2013-2018) Owners Manual: Manual climate control system


To defog inside windshield 1. Set the fan speed to the desired position. 2. Select desired temperature. 3. Press the button. 4. The outside (fresh) air will be selected automatically. If the position is selected, air conditioning (if equipped) will also be selected automatically. If the air cond ...

Copyright © www.kicaman.com 2015-2020