Kia Carens: Body Side Moulding / Rear Spoiler Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Body Side Moulding / Rear Spoiler Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the tail gate upper trim. (Refer to Tail Gate - "Tail Gate Trim")

2.	Disconnect the washer nozzle hose (A) and high mounted stop lamp connector (B).

Loosen the rear spoiler mounting nuts (A).

Tightening torque :

5.9 ~ 6.4N.m (0.6 ~ 0.65kgf.m, 4.3 ~ 4.7lb-ft)

4.	Remove the rear spoiler (A).

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Replace any damaged clips.

Roof Side Moulding Repair procedures

Replacement [General Type] • Put on gloves to protect your hands. ...

Front Wheel Guard Repair procedures

Replacement • Put on gloves to protect your hands. ...

Other information:

Kia Carens RP (2013-2018) Service Manual: PTC Heater (Diesel only) Description and operation

Description The PTC (Positive Temperature Coefficient) heater is installed at the exit or the backside of the heater core. The PTC heater is an electric heater using a PTC element as an auxiliary heating device that supplements deficiency of interior heat source in highly ...

Kia Carens RP (2013-2018) Service Manual: Alignment Repair procedures

Front wheel alignment When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheel ...