Kia Carens: Intake And Exhaust System / Intake Manifold Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Mechanical System / Intake And Exhaust System / Intake Manifold Repair procedures

Removal and Installation

1.	Remove the engine cover.

2.	Disconnect the battery negative terminal.

3.	Remove the air cleaner assembly. (Refer to Intake And Exhaust System-"Air Cleaner")

4.	Disconnect the injector extension connector (A), the VIS (Variable intake system) connector (B) and the PCSV (Purge control solenoid valve) connector (C).

5.	Disconnect the ETC (Electronic throttle control) connector (A) and the MAPS (Manifold absolute pressure sensor) connector (B). (Refer to Engine Control/Fuel System - "ETC(Electronic Threttle Control) System")

6.	Disconnect the knock sensor connector (A).

7.	Disconnect the PCV (Positive crankcase ventilation) hose (A) and the PCSV (Purge control solenoid valve) hose (B).

8.	Disconnect the vacuum hose (A) and the water hoses (B).

Remove the intake manifold (A) with the gasket.

Tightening torque :

18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

When installing, replace with new gaskets.

When installing the intake manifold, tighten the bolts and nuts with pre-torque first, and then tighten the bolts and nuts with specified torque in the sequence shown.

10.	Install in the reverse order of removal.

Intake Manifold Components and components location

Components 1. Intake manifold assembly 2. Intake manifold gasket 3. Electronic throttle body gasket 4. Electronic throttle body 5. Bracket ...

Exhaust Manifold Components and components location

Components 1. Heat protector 2. Exhaust manifold 3. Gasket 4. Exhaust manifold stay ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Front windshield wiper blade

Type A 1. Raise the wiper arm and turn the wiper blade assembly to expose the plastic locking clip. CAUTION Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield. 2. Compress the clip and slide the blade assembly downward. 3. Lift it off the arm. 4. ...

Kia Carens RP (2013-2018) Service Manual: Input Speed Sensor Specifications

Specifications ▷ Type: Hall effect sensor Operation condition [°C(°F)] ((-)40 ~ 150)) -40 ~ 302 Air gap(mm)in. (1.2 ~ 1.8) 0.0472 ~ 0.0709 Output voltage(V) High 1.18 ~ 1.68 ...