Kia Carens: Mirrors / Outside rearview mirror
Be sure to adjust mirror angles before driving.
Your vehicle is equipped with both left-hand and right-hand outside rearview
mirrors. The mirrors can be adjusted remotely with the remote switch. The mirror
heads can be folded back to prevent damage during an automatic car wash or when
passing in a narrow street.
WARNING - Rearview mirrors
- The outside rearview mirror is convex. Objects seen in the mirror are
closer than they appear.
- Use your interior rearview mirror or direct observation to determine
the actual distance of following vehicles when changing lanes.
CAUTION
Do not scrape ice off the mirror face; this may damage the surface of the
glass. If ice should restrict movement of the mirror, do not force the mirror for
adjustment. To remove ice, use a deicer spray, or a sponge or soft cloth with very
warm water.
CAUTION
If the mirror is jammed with ice, do not adjust the mirror by force. Use an
approved spray de-icer (not radiator antifreeze) to release the frozen mechanism
or move the vehicle to a warm place and allow the ice to melt.
WARNING
Do not adjust or fold the outside rearview mirrors while the vehicle is moving.This
could result in loss of control, and an accident which could cause death, serious
injury or property damage.
The electric rearview mirror automatically controls the glare from the headlights
of the vehicle behind you in nighttime or low light driving conditions. The sensor
mounted in the mirror senses the ...
The electric remote control mirror switch allows you to adjust the position of
the left and right outside rearview mirrors.
To adjust the position of either mirror, move the lever (1) to R (Right) o ...
Other information:
WARNING
Always wear appropriate shoes when operating your vehicle. Unsuitable
shoes (high heels, ski boots,etc.) may interfere with your ability to use the
brake, accelerator and clutch (if equipped) pedal.
Do not start the vehicle with the accelerator pedal depressed. The vehicle
can move ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S terminals 2 and 5 [B1/S1].
4.
Measure resistance between ...