Kia Carens: Blind Spot Detection system (BSD) / Blind Spot Detection Switch Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Blind Spot Detection system (BSD) / Blind Spot Detection Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

3.	Remove the lower crash pad switch assembly (A) by pushing it through crash pad side cover hole. And then disconnect the the connetors (B) from the lower crash switch assembly.

Installation

1.	Install the lower crash pad switch assembly after connecting the connectors.

2.	Install the crash pad side cover [LH].

3.	Connect the negative (-) battery terminal.

Inspection

1.	Disconnect the BSD switch connector from the lower crash pad switch assembly.

2.	Operate the BSD switch, then check for continuity between terminals and BSD switch connector.

Blind Spot Detection Switch Schematic diagrams

Circuit Diagram ...

Blind Spot Detection Indicator Components and components location

Components 1. BSD warning lamp 2. Side repeater lamp 3. Puddle lamp ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Fluid Components and components location

Components Location 1. ATF filler hole (eyebolt) 2. ATF level plug 3. ATF drain plug ...

Kia Carens RP (2013-2018) Service Manual: BJ Boot Components and components location

Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ housing 13. TJ ...