Kia Carens: Cooling System / Water Temperature Control Assembly Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures

Removal and Installation

1.	Remove the engine cover.

2.	Drain the engine coolant. (Refer to Cooling System - "Coolant")

3.	Remove the air cleaner assembly. (Refer to Intake And Exhaust System - “Air Cleaner”)

4.	Disconnect the water temperature sensor connector (A).

5.	Disconnect the radiator upper hose and the heater hose from the water temperature control assembly.

Disconnect the water hose (A) and then remove the water temperature control assembly (B) with the O-ring.

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Install in the reverse order of removal.

•	Install a new O-ring when replacing the water temperature control assembly.

•	Clean the surface of the new O-ring, wet it with water and then install it.

8.	Fill the engine coolant. (Refer to Cooling System - "Coolant")

9.	Start the engine and check for leaks.

Water Temperature Control Assembly Components and components location

Components 1. Water temperature assembly 2. Water temperature sensor 3. Gasket 4. Heater pipe ...

Water pump Components and components location

Components 1. Gasket 2. Water pump 3. Water pump pulley ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Fog Lamps Repair procedures

Inspection Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch. [LHD] [RHD] ...

Kia Carens RP (2013-2018) Service Manual: CVVT & Camshaft Repair procedures

Removal 1. Remove the cylinder head cover. (Refer to Cylinder Head Assembly - "Cylinder Head Cover") 2. Turn the crankshaft damper pulley so that No. 1 piston is at top dead center. (1) ...