Kia Carens: Engine Control System / Variable Intake Solenoid (VIS) Valve Repair procedures
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the VIS valve connector.
|
| 3. |
Measure resistance between VIS valve terminals 1 and 2.
|
Specification: Refer to "Specification"
|
|
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-)
cable.
|
| 2. |
Disconnect the variable intake solenoid valve connector (A).
|
| 3. |
Disconnect the vacuum hoses (B) from the valve.
|
| 4. |
Remove the installation bolt, and then remove the valve (C) from the
surge tank.
|
| • |
Install the component with the specified torques.
|
| • |
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
|
|
| • |
Use care to keep foreign material out of the valve.
|
|
| 1. |
Installation is reverse of removal.
|
Circuit Diagram
(M/T)
(A/T)
...
Description
Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and
controls fuel flow flowing into the injectors in accordance with the ECM signal
calculat ...
Other information:
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
3.
Disconnect the BSD connector (A).
4. ...
Circuit Diagram
[First Row Seat]
[Second Row Seat]
...
Variable Intake Solenoid (VIS) Valve Schematic diagrams
Fuel Pressure Control Valve Description and operation