Kia Carens: Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Repair procedures

Kia Carens RP (2013-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Transaxle Oil Temperature Sensor Repair procedures

Inspection

1.	Turn ignition switch OFF.

2.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air cleaner")

3.	Disconnect the solenoid valve connector (A).

4.	Measure the resistance between + terminal (9) and - terminal (13).

Check that the resistance is within the specification.

Item	Specification
Temp.[(°C)°F] / Resistance (kΩ)	(-40) to 40 / 48.1
	(-20) to 4.0 / 15.6
	(0)32.0 / 5.88
	(20)68.0 / 2.51
	(40)104.0 / 1.19
	(60)140.0 / 0.61
	(80)176.0 / 0.32
	(100)212.0 / 0.18
	(120)248.0 / 0.10
	(140)284.0 / 0.06
	(150)302.0 / 0.05

Removal

The oil temperature sensor is integrated with the solenoid valve main connector and can not be disassembled. The oil temperature sensor should be replaced with the solenoid valve main connector.

1.	Move the shift lever to "N" range.

2.	Remove the valve body assembly. (Refer to Hydraulic System - "Valve Body")

3.	Disconnect the input & output speed sensor connector (A).

Loosen the solenoid valve harness bolts (B).

Tightening torque :

9.8-11.8 N.m (1.0-1.2 kgf.m, 7.2-8.7 lb-ft)

5.	Disconnect the solenoid valve connector (A).

Remove the clip (B) and then remove the connector by pressing it downward.

Tightening torque :

9.8-11.8 N.m (1.0-1.2 kgf.m, 7.2-8.7 lb-ft)

Installation

1.	Install in the reverse order of removal.

•	Refill the automatic transaxle with fluid. (Refer to Hydraulic System - "Fluid")

•	Confirm that there is no fluid leakage on connections after repairing.

Transaxle Oil Temperature Sensor Schematic diagrams

Circuit Diagram ...

Input Speed Sensor Description and operation

Description • Input speed sensor uses an electric current type hall sensor in which the current is changed by the magnetic variation. • ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Hood Latch Components and components location

Component Location 1. Hood upper latch assembly 2. Hood lower latch assembly ...

Kia Carens RP (2013-2018) Service Manual: Starter Components and components location

Components 1. Screw 2. Front housing 3. Stop ring 4. Stopper 5. Overrunning clutch 6. Lever 7. Lever plate 8. Lever packing 9. Magnet switch assembly 10. Armature assembly 11. Yoke assembly 12. Brush (-) 13. Brus ...