Kia Carens: Using a child restraint system / Suitability of each seating position for "universal" category belted child restraint systems according to ECE regulations

Kia Carens RP (2013-2018) Owners Manual / Safety features of your vehicle / Child restraint system / Using a child restraint system / Suitability of each seating position for "universal" category belted child restraint systems according to ECE regulations

Use child restraint systems that have been officially approved and are appropriate for your children.

When using the child restraint systems, refer to the following table.

U : Suitable for "universal" category restraints approved for use in this mass group
U* : Suitable for "universal" but 2nd seat should be located foremost position

WARNING

We recommend that a child restraint seat be installed in the rear seat, even if the front passenger's air bag ON/OFF switch is set to the OFF position. To ensure the safety of your child, the front passenger’s air bag must be deactivated when it should be necessary to install a child restraint seat on the front passenger seat in exceptional circumstances.

Installing a child restraint system with a lap/shoulder belt
To install a child restraint system on the seat, do the following: 1. For stable and safe installation of child restraint system, adjust the vehicle seat (seatback angle and/or seat forward and back ...

Suitability of each seating position for "universal" category belted child restraint systems according to ECE regulations - For i-size Child Restraints Systems
i-U = Suitable for i-Size "universal" Child Restraints Systems forward and rearward facing. X = Seat position not suitable for i-size CRS. ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Blower Unit Components and components location


Components 1. Intake Seal 2. Intake Joint Duct 3. Case To Case Clip 4. Intake Upper Case 5. Antinoise Pad 6. Intake Actuator Motor Assembly 7. Intake Door Assembly 8. Intake Lower Case 9. Blower Upper Case 10. Air Filter 11 ...

Kia Carens RP (2013-2018) Service Manual: Hood Latch Release Handle Repair procedures


Replacement 1. Using a screwdriver or remover, remove the hood release handle (A).    • Use a 6mm hex bit to press the c ...

Copyright © www.kicaman.com 2015-2019