Kia Carens: Smart Parking Assist System (SPAS) / Smart Parking Assist System Sensor Repair procedures
Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Smart Parking Assist System (SPAS) / Smart Parking Assist System Sensor Repair procedures
| Removal |
Front/Rear SPAS Sensor
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front/ rear bumper cover.
(Refer to Body - "Front Bumper Cover")
(Refer to Body - "Rear Bumper Cover")
|
| 3. |
Disconnect the connector from the ultrasonic sensor.
[Front]
[Rear]
|
| 4. |
Pull out ths ultrasonic sensor (A) by opening the sensor holder out.
[Front]
[Rear]
|
Side SPAS Sensor
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Disconnect the connector from the ultrasonic sensor.
|
| 4. |
Pull out ths ultrasonic sensor (A) by opening the sensor holder out.
|
| Installation |
Front/Rear SPAS Sensor
| 1. |
Install the SPAS sensor and connector.
|
| 2. |
Install the front/rear bumper cover.
|
Side SPAS Sensor
| 1. |
Install the SPAS sensor and connector.
|
| 2. |
Install the front bumper cover.
|
Smart Parking Assist System Sensor Components and components location
Component (1)
...
Other information:
Kia Carens RP (2013-2018) Service Manual: License Lamps Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp assembly (A) after loosening the mounting screw. 3. Replace the bulb (B) after removing the license lamp (A). ...
Kia Carens RP (2013-2018) Service Manual: Injector Troubleshooting
Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is from the low side (ground side) of the #1 injector and the bottom waveform is from th ...
Copyright © www.kicaman.com 2015-2025
