Kia Carens: Manual Transaxle Control System / Shift Lever Repair procedures

Kia Carens RP (2013-2018) Service Manual / Manual Transaxle System / Manual Transaxle Control System / Shift Lever Repair procedures

Removal

1.	Disconnect the gear boots and then remove the knob and boots by Rotating counter-clockwise shift lever knob (A).

2.	Remove the floor Interior console assembly. (Refer to Body - "Floor Console")

3.	Remove the brakcet (A).

4.	Remove the select cable (B) after removing the clip (A).

5.	Remove the shift cable (A) after removing the clip.

6.	Remove the cable socket clip (A) from lever assembly after pulling in the direction of the arrow.

Remove the shift lever assembly (A) by removing the bolts (4ea).

Tightening torque:

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Installation

Install in the reverse order of removal.

When installing, set room side shift lever and T/M side lever to "N" position.

Inspection

1.	Check operating of lever of T/M side when operating shift lever after assembly.

2.	When shift lever to "R" position, check the position of "skirt".

3.	When lever is shifted to each position, if stop occur between two position, re-adjust select cable. (Refer to Control cable - "Adjustment")

Shift Lever Components and components location

Components 1. Knob 2. Boots 3. Shift lever assembly 4. Select cable clip 5. Shift cable clip 6. Shift cable 7. Select cable 8. Cable retain ...

Control Cable Components and components location

Components 1. Knob 2. Boots 3. Shift lever assembly 4. Select cable clip 5. Shift cable clip 6. Shift cable 7. Select cable 8. Cable retain ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Troubleshooting

Troubleshooting Ignition System Symptom Suspect Area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch Inspect ignition lock switch, or replace as required ...

Kia Carens RP (2013-2018) Service Manual: Fog Lamps Repair procedures

Inspection Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch. [LHD] [RHD] ...