Kia Carens: Seat Electrical / Seat Heater Switch Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Repair procedures

Removal

First Row Seat

1.	Disconnect the negative (-) battery terminal.

2.	Remove the console front complete assembly. (Refer to Body - "Floor Console Assembly")

3.	Disconnect the multimedia connectors (A) from the console front complete assembly.

4.	Disconnect the connector (A) from the heater switch. [Driver's Side] [Passenger's Side]

5.	Remove the heater switch (A) after loosening the mounting screws. [Driver's Side] [Passenger's Side]

Second Row Seat

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

3.	Remove the power window switch (A) after loosening the mounting screws.

Installation

First Row Seat

1.	Install the heater switch.

2.	Install the console front complete assembly.

3.	Connect the negative (-) battery terminal.

Second Row Seat

1.	Install the power window switch.

2.	Install the rear door trim.

3.	Connect the negative (-) battery terminal.

Inspection

First Row Seat

1.	Disconnect the negative (-) batttery terminal.

2.	Remove the console front complete assembly. (Refer to Body - "Floor Console Assembly")

3.	Operate driver seat heater switch and check that continuity exists between the terminals. If there is no continuity, replace the seat heater switch. [Driver's Side] [Passenger's Side]

Second Row Seat

1.	Disconnect the negative (-) batttery terminal.

2.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

3.	Operate driver seat heater switch and check that continuity exists between the terminals. If there is no continuity, replace the seat heater switch.

Seat Heater Switch Schematic diagrams

Circuit Diagram [First Row Seat] [Second Row Seat] ...

Seat Heater (Non-Air Ventilation) Components and components location

Components ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Accelerator Position Sensor (APS) Description and operation

Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine control system, so it consists of the two sensors which adapt individual ...

Kia Carens RP (2013-2018) Service Manual: Fog Lamps Repair procedures

Inspection Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction switch. [LHD] [RHD] ...