Kia Carens: Keyless Entry And Burglar Alarm / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Keyless Entry And Burglar Alarm / Repair procedures

Inspection

Front Door Lock Module Inspection

1.	Remove the front door trim. (Refer to Body - "Front Door Trim")

2.	Remove the front door module. (Refer to Body - "Front Door Module")

3.	Disconnect the connectors from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily. [Central Lock] [Dead Lock]

5.	Check for continuity between the terminals in each switch position according to the table.

Rear Door Lock Module Inspection

1.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

2.	Remove the rear door module. (Refer to Body - "Rear Door Module")

3.	Disconnect the connectors from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily. [Central Lock] [Dead Lock]

5.	Check for continuity between the terminals in each switch position according to the table.

Tailgate Lock Module Inspection

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the 4P connector from the actuator.

3.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Open Switch

1.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

2.	Disconnect the connector from the actuator.

3.	Check for continuity between the terminals in each switch position according to the table.

Hood Switch

1.	Disconnect the connector (A) and bolts from the hood switch.

2.	Check for continuity between the terminals and ground according to the table.

Burglar Horn

1.	Remove the burglar horn (B) after removing a bolt and disconnect the 2P connector (A) from the burglar horn.

2.	Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.

3.	The burglar horn should sound. If the burglar horn fails to sound replace it.

Description and operation

Description Burglar Alarm State [B/A State] B/A State Description DISARM 1) In "DISARM" ...

Transmitter Repair procedures

Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the ba ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Emergency Stop Signal (ESS)

The Emergency Stop Signal system alerts the driver behind by blinking the stop light when the vehicle is braked rapidly and severely. The system is activated when: The vehicle suddenly stops (vehicle speed is over 55km/h and the vehicle deceleration at greater than 7 m/s2) The ABS is activatin ...

Kia Carens RP (2013-2018) Service Manual: Knock Sensor (KS) Description and operation

Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pre ...