Kia Carens: Panorama sunroof / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Panorama sunroof / Repair procedures

Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it.
Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)

2.
Completely open the movable glass using the panorama sunroof switch.
3.
Remove both sides of the decoration cover (A) by pulling it in the direction of the arrow.

4.
Completely close the movable glass using the panorama sunroof switch.
5.
Adjust the height of the glass by slighty loosening the screws (A).
  
Be careful not to damage the screw.

Emergency operation
1.
Use the panorama sunroof emergency operation only when you have to open or close the sunroof when there is a problem with the engine.
2.
Use a hexagon wrench to open or close the panorama sunroof after removing the roof trim. Do not apply too much force when opening or closing the panorama sunroof.
[Movable Glass Motor ]

[Roller Blind Motor]

3.
If needed reset the panorama sunroof according to the reset method.
Components and components location
Components 1. Front roof side moulding [RH] 2. Front roof side moulding [LH] 3. Rear roof side moulding [RH] 4. Rear roof side moulding [LH] 5. Front gl ...

Movable Glass Repair procedures
Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Remove both sides of the decoration cover (A) ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Engine compartment precautions (Diesel engine)


The injector operates at high voltage (maximum 200v). Therefore, the following accidents may occur. - Direct contact with the injector or injector wiring may cause electric shock or damage your muscle or nerve system. - The electromagnetic wave from the operating injector may cause the artif ...

Kia Carens RP (2013-2018) Service Manual: Inhibitor Switch Repair procedures


Inspection    Inspect the following items by referring to inspection flow chart. (Refer to Inhibitor Switch - "Troubleshooting") 1. Check the diagnostic trouble c ...

Copyright © www.kicaman.com 2015-2026