Kia Carens: Restraint / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Restraint / Repair procedures

Component Replacement After Deployment
  
Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
SRSCM
Deployed airbag(s)
Seat belt pretensioner(s)
Front impact sensors
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the side/curtain airbag(s) deployed after a collision, replace the following items.
SRSCM
Deployed airbag(s)
Side impact sensor(s) for the deployed side(s)
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.
Description and operation
Warning Lamp Activation Warning Lamp Behavior after Ignition On As soon as the operating voltage is applied to the SRSCM ignition input, the SRSCM activates the wa ...

Components and components location
Components [LHD] 1. Driver Airbag (DAB) 2. Steering Wheel 3. Clock Spring 4. Seat Belt Pretensioner (BPT) 5. Side Impact Sensor (SIS) 6. Pressure Si ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Blower Resistor (Manual) Repair procedures


Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement ...

Kia Carens RP (2013-2018) Owners Manual: Engine coolant


The high-pressure cooling system has a reservoir filled with year-round antifreeze coolant. The reservoir is filled at the factory. Check the antifreeze protection and coolant concentration level at least once a year, at the beginning of the winter season, and before traveling to a colder climate ...

Copyright © www.kicaman.com 2015-2025