Kia Carens: Restraint / Description and operation
Warning Lamp Behavior after Ignition
On |
As soon as the operating voltage is applied to the SRSCM ignition input, the
SRSCM activates the warning lamp for a LED lamp check.
The lamp shall turn on for 6 seconds during the initialization phase and be
turned off afterward.
To alert the driver, the warning lamp shall turn on for 6 seconds and off for
one second then on continuously after the operating voltage is applied if any
active fault exists.
1. |
Active fault or historical fault counter is greater or equal to 10.
|
2. |
Normal or historical fault counter is less than 10.
|
3. |
When turning the ignition switch ON during variant coding (EOL) mode,
the airbag warning lamp is turned on and blinks at intervals of 1 second
till the coding is completed.
In case the variant coding is normally completed, the airbag warning
lamp is turned on for 6 seconds, and then turned off. Otherwise the
airbag warning lamp continuously blinks at intervals of 1 second.
(1) |
In case the variant coding is normally completed
|
(2) |
In case the variant coding is not completed
|
When there is active fault in airbag system or SRSCM internal fault,
the variant coding (EOL) can’t be completed. In this case, do the
variant coding (EOL) procedure again after troubleshooting with the
GDS.
|
SRSCM Independent Warning Lamp Activation
There are certain fault conditions in which the SRSCM cannot function and thus
cannot control the operation of the standard warning lamp. In these cases, the
standard warning lamp is directly activated by appropriate circuitry that operates
independently of the SRSCM. These cases are:
1. |
Loss of battery supply to the SRSCM : warning lamp turned on continuously.
|
2. |
Loss of internal operating voltage : warning lamp turned on continuously.
|
3. |
Loss of Microprocessor operation : warning lamp turned on continuously.
|
4. |
SRSCM not connected : warning lamp turned on continuously.
|
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag
system service.
Observe the instructions described in ...
Component Replacement After
Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer to ...
Other information:
Here are some important points if you decide to pull a trailer:
Consider using a sway control.You can ask a hitch dealer about sway control.
Do not do any towing with your car during its first 2,000 km (1,200 miles)
in order to allow the engine to properly break in. Failure to heed this caution ...
Description
This specification applies to HCU(Hydraulic Control Unit) and ECU(Electronic
Control Unit) of the HECU.(Hydraulic and Electronic Control Unit)
This specification is for the wiring design and installation of ABS/ESP ECU.
This unit has the functions as follows ...