Kia Carens: Using a child restraint system / Recommended child restraint systems

Kia Carens RP (2013-2018) Owners Manual / Safety features of your vehicle / Child restraint system / Using a child restraint system / Recommended child restraint systems

❈ The 2nd row seat should be located their rearmost position when installing the child restraint system (CRS).
*1 : Part number - 55761SBA00 (When you buy at the authorized Kia dealer)
*2 : Part number – 184066 (Pearl), 363000 (FamilyFix)

WARNING

If you install the child restraint system(CRS) with support leg, you should have to remove the “Floor under tray cover”. Do not install the support leg on the floor under tray cover. For more detail about “floor under tray” refer to “Storage compartment” in chapter 4.

Suitability of each seating position for ISOFIX child restraint systems according to ECE regulations
IUF = Suitable for ISOFIX forward child restraints systems of universal category approved for use in the mass group. IL = Suitable for particular ISOFIX child restraints systems (CRS) approved for ...

Air bag - supplemental restraint system
\ (1) Driver’s front air bag (2) Passenger’s front air bag (3) Side air bag (if equipped) (4) Curtain air bag (if equipped) (5) Passenger’s front air bag ON/OFF switch (if equipped) WARNING Ev ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Receiver-Drier Repair procedures


Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tightening torque : 9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) ...

Kia Carens RP (2013-2018) Service Manual: Steering Angle Sensor Description and operation


Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction and speed of the steering wheel. The HECU uses the signals from th ...

Copyright © www.kicaman.com 2015-2020