Kia Carens: Rear Wiper/Washer / Rear Wiper Motor Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Repair procedures

Inspection
Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.
No.
Description
1
Battery (+)
2
Parking
3
Switch
4
Ground

Automatic Stop Operation Check
1.
Operate the motor at low speed using the stalk control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 2.
3.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1.
4.
Check that the motor stops running at the off position.

Removal
1.
Detach the rear wiper cap (A).

2.
Remove the rear wiper arm & blade (A) after removing rear wiper HEX nut (B).

3.
Remove the rear wiper cap & pad (A).

4.
Remove the tailgate trim after opening the tailgate.
(Refer to Body - "Tailgate Trim")
5.
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts.

Installation
1.
Install the rear wiper motor assembly.
Tightening torque Nut :
6.9~9.8 Nm (0.7~1.0 kgf.m, 5.0~7.2 lbf.ft)
2.
Install the tailgate trim.
3.
Install the rear wiper arm cap after tighting the nut.
Tightening torque Bolt :
3.9~6.9 N.m (0.4~0.7 kgf.m, 2.9~5.1 lbf.ft)
4.
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
A : Auto stop position

Components and components location
Component Location 1. Head cap 2. Rear wiper arm nut 3. Rear wiper arm & blade 4. Cap & pad assembly 5. Rear wiper motor assembly 6. Rear w ...

Rear Washer Switch Repair procedures
Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Using the Tire Mobility Kit (TMK)


1. Detach the speed restriction label (0) from the sealant bottle (1), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast. 2. Shake the sealant bottle. 3. Screw connection hose (9) onto the connector of the sealant b ...

Kia Carens RP (2013-2018) Service Manual: Troubleshooting


Troubleshooting Trouble symptom Suspect area Remedy  Abnormal noise Oil level (Low) To adding oil after inspect the parts. (oil seal, drain plug, filler plug) Oil (Wrong or contam ...

Copyright © www.kicaman.com 2015-2025