Kia Carens: Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement
[Second row seat belt retractor]
  
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim")
2.
After loosening the mounting bolt, then remove the second row seat belt upper anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
After loosening the mounting bolts, then remove the second row seat belt retractor (A).
Tightening torque :
(B) 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
(C) 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Install in the reverse order of removal.
  
Make sure the connector is plugged in properly.
Replace any damaged clips.
[Third row seat belt retractor]
  
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim")
2.
After loosening the mounting bolt, then remove the third row seat belt lower anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
After loosening the mounting bolts, then remove the third row seat belt retractor (A).
Tightening torque :
(B) 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)
(C) 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Install in the reverse order of removal.
  
Make sure the connector is plugged in properly.
Replace any damaged clips.
Rear Seat Belt Retractor Components and components location
Component Location 1. Second row seat belt retractor 2. Third row seat belt retractor ...

Rear Center Seat Belt Retractor Components and components location
Component Location 1. Second row center seat belt retractor ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Emergency Fastening Device (EFD) Description and operation


Description Front emergency fastening device operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and it is an equipment to make up for the existing short stroke. Front emerg ...

Kia Carens RP (2013-2018) Service Manual: Blower Unit Components and components location


Components 1. Intake Seal 2. Intake Joint Duct 3. Case To Case Clip 4. Intake Upper Case 5. Antinoise Pad 6. Intake Actuator Motor Assembly 7. Intake Door Assembly 8. Intake Lower Case 9. Blower Upper Case 10. Air Filter 11 ...

Copyright © www.kicaman.com 2015-2026