Kia Carens: Rear parking assist system / Rear parking assist system precautions
- The rear parking assist system may not sound sequentially depending on the
speed and shapes of the objects detected.
- The rear parking assist system may malfunction if the vehicle bumper height
or sensor installation has been modified or damaged. Any non-factory installed
equipment or accessories may also interfere with the sensor performance.
- The sensor may not recognize objects less than 30 cm (11.8 in.) from the
sensor, or it may sense an incorrect distance. Use caution.
- When the sensor is frozen or stained with snow, dirt, or water, the sensor
may be inoperative until the stains are removed using a soft cloth.
- Do not push, scratch or strike the sensor. Sensor damage could occur.
✽ NOTICE
This system can only sense objects within the range and location of the sensors;
it can not detect objects in other areas where sensors are not installed. Also,
small or slim objects, such as poles or objects located between sensors may not
be detected by the sensors.
Always visually check behind the vehicle when backing up. Be sure to inform
any drivers of the vehicle that may be unfamiliar with the system regarding the
systems capabilities and limitations.
WARNING
Pay close attention when the vehicle is driven close to objects on the road,
particularly pedestrians, and especially children. Be aware that some objects may
not be detected by the sensors, due to the object’s distance, size or material,
all of which can limit the effectiveness of the sensor. Always perform a visual
inspection to make sure the vehicle is clear of all obstructions before moving the
vehicle in any direction.
The rear parking assist system may not operate properly when:
1. Moisture is frozen to the sensor. (It will operate normally when the moisture
has been cleared.)
2. The sensor is covered with foreign ...
When you shift the gear to the R (Reverse) position and if one or more of the
below occurs you may have a malfunction in the rear parking assist system.
• You don't hear an audible warning sound or ...
Other information:
Replacement
1.
Using a clip remover, detach the clips, and remove the hood insulator
pad (A).
•
Be careful not to s ...
Replacement
•
Put on gloves to protect your hands.
•
When ...