Kia Carens: SRSCM / PAB ON/OFF Switch Repair procedures

Kia Carens RP (2013-2018) Service Manual / Restraint / SRSCM / PAB ON/OFF Switch Repair procedures

Removal

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Remove the crash pad side cover. (Refer to Body - "Crash pad side cover")

4.	Disconnect the PAB ON/OFF switch connector (A).

5.	Remove the PAB ON/OFF switch.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Install the PAB ON/OFF switch to the crash pad side cover.

4.	Connect the PAB ON/OFF switch connector.

5.	Install the crash pad side cover. (Refer to Body - "Crash pad side cover")

After installing the SRSCM, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

PAB ON/OFF Switch Components and components location

Components ...

Airbag Module

...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Condition of ISG system operation

The ISG system will operate under the following condition: - The driver’s seat belt is fastened. - The driver’s door and engine hood are closed. - The brake vaccum pressure is adequate. - The battery is sufficiently charged. - The engine coolant temperature is not too low. - The slope way is gen ...

Kia Carens RP (2013-2018) Service Manual: Rear Wiper Motor Repair procedures

Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively. 3. Check that the motor op ...