Kia Carens: Fuel Delivery System / Delivery Pipe Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Fuel Delivery System / Delivery Pipe Repair procedures

Removal

In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)

When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.

3.	Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold")

4.	Disconnect the injector connectors (A) and the rail pressure sensor connector (B).

5.	Remove the high pressure fuel pipe (C).

6.	Remove the engine oil gauge.

7.	Remove the installation bolt (D), and then remove the delivery pipe and injector assembly from the engine.

Installation

•	Do not use already used injector fixing clip again.

Do not reuse the support disc.

Do not reuse the injector rubber washer.

Do not reuse the combustion seal.

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.

•	Apply engine oil to the injector O-ring.

•	Do not use already used injector O-ring again.

•	Do not use already used bolt again.

•	When insert the injector, be careful not to damage the injector tip.

Installation is reverse of removal.

Delivery pipe installation bolt:

18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

High pressure fuel pipe installation nut:

26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 lb-ft)

Accelerator Pedal Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sens ...

High Pressure Fuel Pump Repair procedures

Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and inject ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Glow Indicator Light (Diesel Engine)

This indicator light illuminates: • When the engine is being preheated with the ignition switch or Engine Start/Stop Button in the ON position. - The engine can be started after the glow indicator light goes off. - The illumination time varies with the engine coolant temperature, air temperature ...

Kia Carens RP (2013-2018) Service Manual: Components and components location

Components 1. Timing chain 2. Timing chain guide 3. Timing chain arm 4. Timing chain auto tensioner 5. Timing chain cover 6. Drive belt idler 7. Water pump gasket 8. Water pump 9. ...