Kia Carens: Front / Rear Parking Assist System / Parking Assist Sensor Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Front / Rear Parking Assist System / Parking Assist Sensor Repair procedures

Removal
Front/Rear PAS Sensor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front/ rear bumper cover.
(Refer to Body - "Front Bumper Cover")
(Refer to Body - "Rear Bumper Cover")
3.
Disconnect the connector from the ultrasonic sensor.
[Front]

[Rear]

4.
Pull out ths ultrasonic sensor (A) by opening the sensor holder out.
[Front]

[Rear]

Installation
Front/Rear PAS Sensor
1.
Install the PAS sensor and connector.
2.
Install the front/rear bumper cover.
Parking Assist Sensor Schematic diagrams
Circuit Diagram ...

Ignition Switch Assembly
...

Other information:

Kia Carens RP (2013-2018) Service Manual: Seat Belt Pretensioner (BPT) Repair procedures


Removal 1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Without EFD - Remove the lower anchor bolt. Witht EFD - To remove the emergency fastening device (C), keep o ...

Kia Carens RP (2013-2018) Service Manual: Instrument Cluster Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the cluster fascia panel. (Refer to Body - "Cluster Fascia Panel") 3. Remove the cluster (A) after removing 2 screws. ...

Copyright © www.kicaman.com 2015-2022