Kia Carens: Engine Control System / CVVT Oil Control Valve (OCV) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Engine Control System / CVVT Oil Control Valve (OCV) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the OCV connector.

3.	Measure resistance between the OCV terminals 1 and 2.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the CVVT oil control valve connector (A).

3.	Remove the installation bolt (B), and then remove the valve from the engine. [Bank 1 / Intake] [Bank 1 / Exhaust]

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Apply engine oil to the valve O-ring.

Installation is reverse of removal.

CVVT oil control valve installation bolt:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

CVVT Oil Control Valve (OCV) Schematic diagrams

Circuit Diagram (M/T) (A/T) ...

Variable Intake Solenoid (VIS) Valve Description and operation

Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake m ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Snowy or Icy conditions

To drive your vehicle in deep snow, it may be necessary to use snow tires or to install tire chains on your tires. If snow tires are needed, it is necessary to select tires equivalent in size and type of the original equipment tires. Failure to do so may adversely affect the safety and handling o ...

Kia Carens RP (2013-2018) Service Manual: Transaxle Oil Temperature Sensor Description and operation

Description • The sensor used is a thermistor (NTC) in which resistance changes with temperature variation. • The TCM supplies about 5 voltage to the sensor; the output value changes with ATF temperature. ...