Kia Carens: Ignition System / Ignition Coil Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Electrical System / Ignition System / Ignition Coil Repair procedures

Removal
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the ignition coil connector (A).

  
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).

4.
Remove the ignition coil (A).

Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
Inspection
1.
Measure the primary coil resistance between terminals (+) and (-).

Standard value: 0.79Ω ± 15%
Ignition Coil Schematic diagrams
Circuit Diagram ...

Spark Plug Description and operation
Description A spark plug is a device for delivering electric current from an ignition system to the combustion chamber of a spark-ignition engine to ignite the compressed fuel/ai ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Auto stop


To stop the engine in idle stop mode With manual transaxle 1. Decrease the vehicle speed to less than 5 km/h (3 mph). 2. Shift into N (Neutral) position. 3. Release the clutch pedal. With dual clutch transmission 1. Decrease the vehicle speed to 0 km/h. 2. Shift into D (Drive) or N (Neutral) positi ...

Kia Carens RP (2013-2018) Owners Manual: Warning type


The system will activate when: 1.The system is on 2.Vehicle speed is above 30 km/h (18.6 mph) 3.Other vehicles are detected in the rear side WARNING The Blind Spot Detection System (BSD) is not a substitute for proper and safe driving. Always drive safely and use caution when changing lanes or back ...

Copyright © www.kicaman.com 2015-2022