Kia Carens: Fuses And Relays / ICM (Integrated Circuit Module) Relay Box Repair procedures
Burglar Alarm Relay
Check for continuity between the terminals.
| 1. |
There should be continuity between the No.5 and No.13 terminals when
power and ground are connected to the No.5 and No.3 in the ICM-A.
|
Rear Wiper Relay
Check for continuity between the terminals.
| 1. |
There should be continuity between the No.14 and No.20 terminals when
power and ground are connected to the No.12 and No.16 in the ICM-A.
|
Folding Motor Relay
Check for continuity between the terminals.
| 1. |
There should be continuity between the No.15 and No.18 terminals when
power and ground are connected to the No.2 and No.5 in the ICM-B.
|
Unfolding Motor Relay
Check for continuity between the terminals.
| 1. |
There should be continuity between the No.13 and No.17 terminals when
power and ground are connected to the No.14 and No.5 in the ICM-B.
|
Door Lock Actuator Relay
Check for continuity between the terminals.
| 1. |
There should be continuity between the No.4 and No.12 terminals when
power and ground are connected to the No.3 and No.1 in the ICM-B.
|
Turn Signal Sound Relay
Check for continuity between the terminals.
| 1. |
There should be continuity between the No.15 and No.18 terminals when
power and ground are connected to the No.17 and No.6 in the ICM-A.
|
Description
The ICM relay is united with (buglar alarm relay, rear wiper relay, fold/unfold
motor relay, turn signal sound relay, rear fog relay, door lock actuator relay,
head l ...
Other information:
This system provides further enhancements to vehicle stability and steering responses
when a vehicle is driving on a slippery road or a vehicle detected changes in coefficient
of friction between right wheels and left wheels when braking.
VSM operation
When the VSM is operating:
ESC (Electronic ...
1. Pull the wheel guard down by rotating the screws.
2. Reach your hand into the back of the front bumper.
3. Disconnect the power connector from the socket.
4. Remove the bulb-socket from the housing by turning the socket counter clockwise
until the tabs on the socket align with the slots on the ...