Kia Carens: Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the HO2S connector.

3.	Measure resistance between the HO2S terminals 2 and 5 [B1/S1].

4.	Measure resistance between the HO2S terminals 3 and 4 [B1/S2].

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

Disconnect the connector (A), and then remove the sensor (B).

Note that the SST (Part No.: 09392-1Y100 or 09392-2H100) is useful when removing the heated oxygen sensor.

[Bank 1 / Sensor 1]

[Bank 1 / Sensor 2]

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	DON’T use a cleaner, spray, or grease to sensing element and connector of the sensor because oil component in them may malfunction the sensor performance.

•	Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).

Installation is reverse of removal.

Heated oxygen sensor installation:

39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)

Heated Oxygen Sensor (HO2S) Schematic diagrams

Circuit Diagram (M/T) (A/T) ...

Rail Pressure Sensor (RPS) Description and operation

Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor ele ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Using the Tire Mobility Kit (TMK)

1. Detach the speed restriction label (0) from the sealant bottle (1), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too fast. 2. Shake the sealant bottle. 3. Screw connection hose (9) onto the connector of the sealant b ...

Kia Carens RP (2013-2018) Service Manual: Oil Cooler Repair procedures

Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the air cleaner assembly. (Refer to Intake and exhaust system - "Air Cleaner") 3. Remove the battery tray. ...