Kia Carens: Driveshaft Assembly / Dynamic Damper Components and components location

Kia Carens RP (2013-2018) Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Components and components location

Components

1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ housing
13. TJ circlip

TJ Joint Repair procedures
Replacement    • Special grease must be applied to the driveshaft joint. Do not s ...

Dynamic Damper Repair procedures
Replacement 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint asse ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting


Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

Kia Carens RP (2013-2018) Owners Manual: Glow Indicator Light (Diesel Engine)


This indicator light illuminates: • When the engine is being preheated with the ignition switch or Engine Start/Stop Button in the ON position. - The engine can be started after the glow indicator light goes off. - The illumination time varies with the engine coolant temperature, air temperature ...

Copyright © www.kicaman.com 2015-2024