Kia Carens: Engine Control System / Rail Pressure Sensor (RPS) Description and operation

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

Heated Oxygen Sensor (HO2S) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance betwe ...

Rail Pressure Sensor (RPS) Specifications

Specification ...

Other information:

Kia Carens RP (2013-2018) Service Manual: PTC Heater (Diesel only) Repair procedures

Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the mode to FLOOR. (2) Set the temperature to M ...

Kia Carens RP (2013-2018) Service Manual: Smart Key Diagnostic Repair procedures

Inspection Self Diagnosis With GDS Smart key system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis. The following three features will be major problem in SMART KEY system. 1. ...