Kia Carens: Engine And Transmission Assembly / Engine Room Under Cover Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Room Under Cover Repair procedures

Removal and Installation
Engine Room Under Cover
1.
Remove the engine room under cover (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

2.
Install in the reverse order of removal.
Engine Room Side Cover
1.
Remove the engine room under cover.
2.
Remove the engine room side covers (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
[RH]

[LH]

3.
Install in the reverse order of removal.
Engine Room Under Cover Components and components location
Components 1.  Side cover (LH) 2.  Side cover (RH) 3.  Under cover ...

Engine Mounting Components and components location
Components 1. Transaxle mounting bracket 2. Roll road bracket 3. Engine mounting bracket 4. Engine mounting support bracket ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Troubleshooting


TPMS Inspection method Inspection    Find the inspection number by referring to the table above. The following content is irrelevant of the inspection procedure. 1. ...

Kia Carens RP (2013-2018) Service Manual: Rain Sensor Repair procedures


Inspection Rain Sensing Wiper 1. In IGN2 ON state, if auto switch input (LIN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor input signal. 2. If the wiper switc ...

Copyright © www.kicaman.com 2015-2021