Kia Carens: Warning lights / Electronic Brake force Distribution (EBD) System Warning Light

Kia Carens RP (2013-2018) Owners Manual / Features of your vehicle / Warning and indicator lights / Warning lights / Electronic Brake force Distribution (EBD) System Warning Light

These two warning lights illuminate at the same time while driving:

WARNING - Electronic Brake force Distribution (EBD) System Warning Light

When both ABS and Parking Brake & Brake Fluid Warning Lights are on, the brake system will not work normally and you may experience an unexpected and dangerous situation during sudden braking.

In this case, avoid high speed driving and abrupt braking. We recommend you have the vehicle inspected by an authorized Kia dealer as soon as possible.

✽ NOTICE - Electronic Brake force Distribution (EBD) System Warning Light

When the ABS Warning Light is on or both ABS and Parking Brake & Brake Fluid Warning Lights are on, the speedometer, odometer, or tripmeter may not work. Also, the EPS Warning Light may illuminate and the steering effort may increase or decrease.

In this case, we recommend you have the vehicle inspected by an authorized Kia dealer as soon as possible.

Anti-lock Brake System (ABS) Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a ma ...

Electronic Parking Brake (EPB) Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a ma ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Front Wheel Speed Sensor Repair procedures


Removal 1. Remove the front wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Remove the front wheel speed sensor mounting bolt (A). ...

Kia Carens RP (2013-2018) Service Manual: Field Effect Transistor (DATC) Repair procedures


Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. Select the control switch to raise the voltage until high speed. ...

Copyright © www.kicaman.com 2015-2022