Kia Carens: Blind Spot Detection system (BSD) / Blind Spot Detection Unit Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Blind Spot Detection system (BSD) / Blind Spot Detection Unit Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover")

3.	Disconnect the BSD connector (A).

Remove the BSD unit (B) after loosening the mounting screws.

[LH]

[RH]

Take care not to separate the bracket from rear bumper when removing the BSD sensor.

Installation

1.	Install the BSD units.

2.	Connect the BSD unit connector.

3.	Install the rear bumper cover.

Connect the negative (-) battery terminal.

Do not confuse the left side (master) with the right side (slave) unit when installing the BSD unit.

Blind Spot Detection Unit Schematic diagrams

Circuit Diagram ...

Blind Spot Detection Radar Calibration Description and operation

Description To correctly sense vehicles on the neighboring lanes using the radar, the direction of the sensor and the direction of the vehicle must be aligned. This is the BSD ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Fuel Pump Repair procedures

Inspection [Fuel pump] 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Remove the fuel pump assembly. 3. Check motor operation by fuel pump connector (A) connecting pow ...

Kia Carens RP (2013-2018) Service Manual: Knock Sensor (KS) Description and operation

Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When knocking occurs, the vibration from the cylinder block is applied as pre ...