Kia Carens: Auto Head Lamp Leveling Device / Auto Head Lamp Leveling Unit Description and operation
According to driving environment and loading state of vehicle, head lamp lighting
direction is changed to keep the driver's visibility range and to protect the
driver's vision from glare, aiming at safety driving.
Sensor integrated ECU mounting on the rear center arm drives the actuator mounting
on the head lamp since sensing the input signal following the vehicle's statically
changes.
Head lamp beam is automatically operated by chassis tilt.
Operating Procedure
| 1. |
Suspension angle change resulted from vehicle's load change.
|
| 3. |
Microprocessor calculates necessary head lamp angle change amount.
|
| 4. |
Sending a proper signal to head lamp leveling device and driving actuator.
|
Operating Condition
| 3. |
On stop : If sensor lever change is 0.7° and above, head lamp is operated
after max. 1.5 sec.
|
| 4. |
On driving : If vehicle velocity is over 4km/h(2.48mile/h), velocity
change is not over 0.8-1.6km/h(0.5 ~ 1.0mile/h) per second, and loading
condition is changed, then head lamp is operated.
|
Components
| 1. |
Auto head lamp leveling unit
1. Leveling unit & sensor
2. Sensor mounting bracket
3. Sensor linkage

| • |
Using a Micro-processor, percept the operation lever's mechanical
angle change or speed signal.
|
| • |
As an actuator control device of inner control program, mounting
on the rear center arm.
|
|
| 2. |
Actuator
| • |
Change the head lamp lighting direction up or down since automatic
head lamp leveling unit sensing the input signal following the
vehicle's statically changes.
|
|

Description
According to driving environment and loading state of vehicle, head lamp lighting
direction is changed to keep the driver's visibility range and to protect the
dr ...
Other information:
Fuse Inspection
1.
Be sure there is no play in the fuse holders, and that the fuses are
held securely.
2.
Are the fuse capacities for each circuit correct?
3.
Are there any blown fuses?
If a ...
✽ NOTICE
The transmitter will not work if any of following occur:
The ignition key is in ignition switch.
You exceed the operating distance limit (about 10 m [30 feet]).
The battery in the transmitter is weak.
Other vehicles or objects may be blocking the signal.
The weather is extremely col ...