Kia Carens: Heating,Ventilation And Air Conditioning / Specifications

Kia Carens RP (2013-2018) Service Manual / Heating,Ventilation And Air Conditioning / Specifications

Specification
Air Conditioner
Item
Specification
Compressor
Type
6VSX16 (External Variable Displacement Swash Plate)
Oil type & Capacity
PAG (FD46XG) 100 ± 10cc (3.52 ± 0.35oz.)
Pulley type
6PK-TYPE
Displacement
160cc/rev
Condenser
Heat rejection
DSL : 13,100 Min. kcal/h
GSL : 14,000 Min. kcal/h
Expansion valve
Type
Block type
Refrigerant
Type
HFC-134a or HFO-1234yf
Capacity
550 ± 25g (19.4 ± 0.88oz.)

Blower Unit
Item
Specification
Fresh and recirculation
Operating method
Actuator
Blower
Type
Sirocco
Speed step
Auto + 8 speed (Automatic), 1~4speed (Manual)
Speed control
Power mosfet (Automatic), Resistor (Manual)
Air filter
Type
Particle filter

Heater and Evaporator Unit
Item
Specification
Heater
Type
Pin & Tube type
Heating capacity
4,700 - 5% kcal/hr
Mode operating method
Actuator
Temperature operating method
Actuator
Evaporator
Temperature control type
Evaporator temperature sensor
A/C ON/OFF
ON : 2.1°C (35.8°F)
OFF: 0.6°C (33.1°F)

Tightening Torques
Items
N.m
kgf.m
lb-ft
Compressor
20.0 ~ 32.95
2.04 ~ 3.36
14.75 ~ 24.30
Condenser - Discharge hose
4.9 ~ 7.8
0.5 ~ 0.8
3.6 ~ 5.7
Condenser - Liquid tube
Compressor - Discharge hose
7.8 ~ 11.8
0.8 ~ 1.2
5.7 ~ 8.7
Compressor - Suction hose
Expansion valve - Evaporator
11.8 ~ 14.7
1.2 ~ 1.5
8.7 ~ 10.9

Heating,Ventilation And Air Conditioning
...

Special service tools
Special Service Tools Tool (Number and name) Illustration Use 09977-3R000 Clutch bolt remover Rem ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Seat belt warning


Driver’s seat belt warning (1) If the driver’s seat belt is unfastened after the ignition switch is ON, the seat belt warning light illuminates until the belt is fastened. If you continue not to fasten the seat belt and you drive over 9km/h, the illuminated warning light will start to blink u ...

Kia Carens RP (2013-2018) Service Manual: Yaw-rate and G Sensor Repair procedures


Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Pull the passenger seat towards the front till the end. 3. Disconnect the yaw rate & lateral G sensor connector ...

Copyright © www.kicaman.com 2015-2021