Kia Carens: Intake And Exhaust System / Air Cleaner Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Mechanical System / Intake And Exhaust System / Air Cleaner Repair procedures

Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
3.
Remove the air duct and air cleaner assembly.
Tightening torque
Hose clamp bolt:
2.9 ~ 4.9N.m (0.3 ~ 0.5kgf.m, 2.2 ~ 3.6lb-ft)
Air cleaner assembly bolts:
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
(1)
Remove the air duct (A).

(2)
Disconnect the breather hose (A) and air intake hose (B).
(3)
Remove the air cleaner assembly (C).

4.
Install in the reverse order of removal.
Air Cleaner Element
1.
Open the air cleaner cover by unhooking the clamps.

2.
Replace the air cleaner element (A) with a new one.

  
If there are foreign substances inside the air cleaner assembly, wipe the inside of the air cleaner assembly and then replace the air cleaner element.
3.
Close the air cleaner cover by hooking the clamps.
Resonator
1.
Remove the front bumper cover.
(Refer to Body (Interior and Exterior) - “Front Bumper Cover”)
2.
Remove the resonator (A) after loosening the mounting bolts.
Tightening torque:
7.8 ~ 9.8 N.m (0.8~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

3.
Install in reverse order of removal.
Air Cleaner Components and components location
Components 1. Intake shield 2. Air duct A 3. Air intake hose 4. Air cleaner assembly 5. Air intake adapter 6. Air duct B 7. Resonator ...

Intake Manifold Components and components location
Components 1. Intake manifold assembly 2. Intake manifold gasket 3. Electronic throttle body gasket 4. Electronic throttle body 5. Bracket ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Seat Belt Pretensioner (BPT) Repair procedures


Removal 1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Without EFD - Remove the lower anchor bolt. Witht EFD - To remove the emergency fastening device (C), keep o ...

Kia Carens RP (2013-2018) Owners Manual: Outside light


Rear turn signal light and stop/tail light 1. Turn off the engine. 2. Open the tailgate. 3. Loosen the light assembly retaining screws with a cross-tip screwdriver. 4. Remove the rear combination light assembly from the body of the vehicle. 5. Remove the socket from the assembly by turning the soc ...

Copyright © www.kicaman.com 2015-2023