Kia Carens: Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Repair procedures

Inspection

1.	Connect the GDS on the Data Link Connector (DLC).

2.	Turn the ignition switch ON.

Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.

Specification: Refer to “Specification”

Removal

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator pedal position sensor connector (A).

3.	Remove the accelerator pedal assembly from the vehicle after unscrewing the mounting bolt (B) and nuts (C).

Installation

Installation is reverse of removal.

Accelerator pedal installation bolt:

8.8 ~ 14.7 N.m (0.9 ~ 1.4kgf.m, 6.5 ~ 10.1 lb-ft)

Accelerator pedal module installation nut:

12.7 ~ 15.6 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.5 lb-ft)

When replacing or reinstalling the accelerator pedal, step on the accelerator pedal fully to the end for 1 sec in IG key on position.

Through this procedure, ECM learn full accelator position of the APS.

Accelerator Position Sensor (APS) Schematic diagrams

Circuit Diagram (M/T) (A/T) ...

Injector Description and operation

Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fue ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Parking brake - Hand type

Checking the parking brake Check the stroke of the parking brake by counting the number of “clicks’’ heard while fully applying it from the released position. Also, the parking brake alone should securely hold the vehicle on a fairly steep grade. If the stroke is more or less than specifie ...

Kia Carens RP (2013-2018) Service Manual: Components and components location

Components 1. Parking brake lever 2. Parking brake cable 3. Equalizer assembly ...