Kia Carens: Cruise Control system / To cancel cruise control, do one of the following

Kia Carens RP (2013-2018) Owners Manual / Driving your vehicle / Cruise Control system / To cancel cruise control, do one of the following

Depress the brake pedal.
Depress the clutch pedal if equipped with a manual transaxle.
Shift into N (Neutral) if equipped with an automatic transaxle / dual clutch transmission.
Press the CANCEL button located on the steering wheel.
Decrease the vehicle speed lower than the memory speed by approximately 15 km/h (9 mph).
Decrease the vehicle speed to less than approximately 25 km/h (15 mph).

Each of these actions will cancel cruise control operation (the cruise set indicator light will go off), but it will not turn the system off. If you wish to resume cruise control operation, move up the lever (to RES+) located on your steering wheel. You will return to your previously preset speed.

To temporarily accelerate with the cruise control on

If you want to speed up temporarily when the cruise control is on, depress the accelerator pedal. Increased speed will not interfere with cruise control operation or change the set speed. To return ...

To resume cruising speed at more than approximately 30 km/h (20 mph)

If any method other than the button was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when you move the lever up (to RES+). I ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Parking Brake Cable Repair procedures

Removal The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure. 1. Remove the floor console assembly. ...

Kia Carens RP (2013-2018) Owners Manual: Using the transmitter

Park the vehicle and stop the engine. Arm the system as described below. 1.Turn off the engine and remove the ignition key from the ignition switch. 2.Make sure that all doors, the engine hood and tailgate are closed and latched. 3.Lock the doors by pressing the lock button on the transmitter. After ...