Kia Carens: Clutch Switch / Repair procedures

Kia Carens RP (2013-2018) Service Manual / Clutch System / Clutch Switch / Repair procedures

Inspection

Component Inspection

1.	Remove the clutch switch. (Refer to Clutch Switch - "Removal")

Push the clutch switch in the direction of the arrow to make sure that continuity is cut off.

Condition	Clutch Pedal pressed	Clutch Pedal Released
Switch Operation	ON (below 1.0Ω )	OFF ( Infinite Ω )

Removal

1.	Disconnect the negative (-) battery cable.

2.	Remove the smart junction box. (Refer to Body Electrical System - "Relay Box (Passenger Compartment)")

3.	Disconnect clutch switch connector (A).

4.	Remove the clutch switch (B) by loosening a nut (A).

Installation

1.	Install in the reverse order of removal.

Adjust the clutch switch.

(1)

Adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range:

0.5 ~ 1.0 mm (0.0197 ~ 0.0394 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Specifications

Specifications Item Specifications Working voltage DC 12V Operating force 9.8 ± 2.9N ...

Ignition Lock Switch

...

Other information:

Kia Carens RP (2013-2018) Service Manual: Rear Glass Repair procedures

Removal • In order to remove the rear glass, use the tools shown in the following figure: [Tooling Diagram] ...

Kia Carens RP (2013-2018) Service Manual: Windshield Deicer Repair procedures

Inspection 1. Remove the cowl top cover. (Refer to Body - "Cowl Top Cover") 2. Disconnect the windshield deicer connector (A). 3. Check for continuity between the terminals of de ...