Kia Carens: Horn / Repair procedures
| Removal |
| 1. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 2. |
Remove the bolts and disconnect the horn connectors, then remove the
high pitch horn (A) and low pitch horn (B). And then remove the fixed
clip (C) from the bracket.
|
| Installation |
| 1. |
Install the horns after connecting the horn connectors.
|
| 2. |
Install the front bumper cover.
|
| Inspection |
Test the horn by connecting battery voltage to the 1 terminal and ground the
2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.
Horn Relay Inspection
| 1. |
Remove the horn relay (A) from the engine room relay box.
|
| 2. |
There should be continuity between the No.30 and No.87 terminals when
power and ground are connected to the No.85 and No.86 terminals.
|
| 3. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
Components and components location
Component Location
1. Horn switch
2. Horn relay (Engine room compartment)
3. Horn (High pitch)
4. Horn (Low pitch)
5. Clock spring
...
AVN System
...
Other information:
Kia Carens RP (2013-2018) Service Manual: Rail Pressure Sensor (RPS) Description and operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM ...
Kia Carens RP (2013-2018) Owners Manual: Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When there is a malfunction with the ESC system. In this case, we recommend that you have the vehicle inspected by ...
Copyright © www.kicaman.com 2015-2026
