Kia Carens: Tires and wheels / Recommended cold tire inflation pressures

Kia Carens RP (2013-2018) Owners Manual / Maintenance / Tires and wheels / Recommended cold tire inflation pressures

All tire pressures (including the spare) should be checked when the tires are cold. “Cold Tires” means the vehicle has not been driven for at least three hours or driven less than 1.6 km (1 mile).

Recommended pressures must be maintained for the best ride, top vehicle handling, and minimum tire wear.

For recommended inflation pressure refer to “Tire and wheels” in chapter 9.

All specifications (sizes and pressures) can be found on a label attached to the vehicle.

WARNING - Tire underinflation

Severe underinflation (70 kPa (10 psi) or more) can lead to severe heat build-up, causing blowouts, tread separation and other tire failures that can result in the loss of vehicle control leading to severe injury or death. This risk is much higher on hot days and when driving for long periods at high speeds.

CAUTION

CAUTION

WARNING - Tire inflation

Overinflation or underinflation can reduce tire life, adversely affect vehicle handling, and lead to sudden tire failure. This could result in loss of vehicle control and potential injury.

CAUTION - Tire pressure

Always observe the following:

Tires and wheels
Tire care For proper maintenance, safety, and maximum fuel economy, you must always maintain recommended tire inflation pressures and stay within the load limits and weight distribution recommended ...

Checking tire inflation pressure
Check your tires once a month or more. Also, check the tire pressure of the spare tire. How to check Use a good quality gauge to check tire pressure. You can not tell if your tires are properly infla ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Troubleshooting


Troubleshooting Problem Possible cause Solution Not pairing Bluetooth device of Car is not discoverable mode Enter Bluetooth pairing (searching) mode User’s phone is Bluetooth off mode ...

Kia Carens RP (2013-2018) Owners Manual: Static bending light


Follow the steps 1 to 2 from the previous chapter. 3. Remove the headlight bulb cover by turning it counterclockwise. 4. Disconnect the headlight bulb socket-connector. 5. Unsnap the headlight bulb retaining wire by depressing the end and pushing it upward. 6. Remove the bulb from the headlight as ...

Copyright © www.kicaman.com 2015-2020