Kia Carens: ABS(Anti-Lock Brake System) / Rear Wheel Speed Sensor Repair procedures

Removal

Remove the rear wheel and tire.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Remove the rear wheel speed sensor mounting bolt (A).

Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Remove the rear wheel speed sensor cable mounting bolt (B).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.	Remove the rear wheel house trim clips (A).

5.	Remove the luggage side trim. (Refer to Body - "Luggage Side Trim")

6.	Disconnect the rear wheel speed sensor connector and than remove the rear wheel speed sensor.

Install in the reverse order of removal.

Install the rear sensor after lubricating the O-ring of sensor with the assembly fluid(RAREMAX AF-1)

When inserting the sensor, take care the O-ring not to be damaged.

Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor connector ...

...

Removal 1. Disconnect the battery nagative terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connector (A). ...

Component Location 1. Cowl cross bar assembly ...