Kia Carens: Body Side Moulding / Rear Wheel Guard Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Body Side Moulding / Rear Wheel Guard Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

1.	Remove the rear tire.

2.	Remove the rear mud guard. (Refer to Body Side Moulding - "Rear Mud Guard")

3.	After loosening the mounting clips and screws, then remove the rear wheel guard (A).

Install in the reverse order of removal.

•	Replace any damaged clips.

Front Wheel Guard Repair procedures

Replacement • Put on gloves to protect your hands. ...

Front Mud Guard Repair procedures

Replacement • Put on gloves to protect your hands. ...

Other information:

Kia Carens RP (2013-2018) Service Manual: Intake Air Temperature Sensor (IATS) Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the IATS connector. 3. Measure resistance between the IATS terminals 3 and 4. 4. Check that the resistance is within ...

Kia Carens RP (2013-2018) Service Manual: ICM (Integrated Circuit Module) Relay Box Repair procedures

Inspection Burglar Alarm Relay Check for continuity between the terminals. 1. There should be continuity between the No.5 and No.13 terminals when power and ground are connected to the No.5 and No.3 in the ICM-A. Rear Wiper Relay Ch ...