Kia Carens: Lighting System / Rear Combination Lamp Repair procedures
Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Lighting System / Rear Combination Lamp Repair procedures
| Removal |
Rear Combination Lamp (Outside)
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear combination lamp (A) after loosening the mounting screws.
|
| 3. |
Disconnect the rear combination lamp connector (A).
|
| 4. |
Replace turn signal lamp (A) and stop/tail lamp (B) by turning the sockets
counterclockwise.
|
Rear Combination Lamp (Inside)
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear combination cover (A).
|
| 3. |
Disconnect the connector (A).
|
| 4. |
Remove the rear lamp assembly after removing the bolts.
|
| 5. |
Replace backup lamp (A) and stop/tail lamp (B) by turning the sockets
counterclockwise.
|
| Installation |
| 1. |
Install the rear combination lamp (Inside) assembly.
|
| 2. |
Install the rear combination lamp (outside) assembly.
|
Luggage Lamp Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the luggage lamp (A).
...
Other information:
Kia Carens RP (2013-2018) Service Manual: Siren & ACU(Alarm Control Unit) Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the left luggage side trim. (Refer to Body - "Interior Trim") 3. Remove the siren (A) after disconnecting the connector ...
Kia Carens RP (2013-2018) Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. Specification: Refer to "Specification" ...
Copyright © www.kicaman.com 2015-2025
