Kia Carens: Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Kia Carens RP (2013-2018) Service Manual / Engine Control / Fuel System / Engine Control System / Purge Control Solenoid Valve (PCSV) Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the PCSV connector.

3.	Measure resistance between the PCSV terminals 1 and 2.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the purge control solenoid valve connector (A).

3.	Disconnect the vapor hoses (B) from the purge control solenoid valve.

4.	Remove the valve after removing the bolt (C).

Installation

•	Install the component with the specified torques.

•	Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.

•	Use care to keep foreign material out of the valve.

Installation is reverse of removal.

Purge control solenoid valve bracket installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Purge Control Solenoid Valve (PCSV) Schematic diagrams

Circuit Diagram (M/T) (A/T) ...

CVVT Oil Control Valve (OCV) Description and operation

Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Rocking the vehicle

If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels. Then, shift back and forth between 1 (First) and R (Reverse) in vehicles equipped with a manual transaxle or R (Reverse) and any forw ...

Kia Carens RP (2013-2018) Service Manual: ABS Control Module Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the battery (A) and ECM (B). 3. Remove the brake fluid from the master cylinder reservoir with ...