Kia Carens: Rear Bumper / Rear Bumper beam Assembly Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper beam Assembly Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")

2.	Remove the rear bumper wiring harness mounting clips (A).

3.	Remove the mounting clips (B), then remove the rear bumper beam assembly (A) and then loosen the clips.

Install in the reverse order of removal.

•	Replace any damaged clips.

Rear Bumper beam Assembly Components and components location

Component Location 1. Rear bumper beam assembly ...

Front Seat

...

Other information:

Kia Carens RP (2013-2018) Owners Manual: 2. Select parking assist mode

Select the parking assist mode by pressing the Smart Parking Assist System button with the shift lever in N (Neutral) or D(Drive) and the brake pedal depressed. The right side parallel mode is selected automatically when the Smart Parking Assist System is activated. To select the left side ...

Kia Carens RP (2013-2018) Owners Manual: Seat belt warning

Driver’s seat belt warning (1) If the driver’s seat belt is unfastened after the ignition switch is ON, the seat belt warning light illuminates until the belt is fastened. If you continue not to fasten the seat belt and you drive over 9km/h, the illuminated warning light will start to blink u ...