| Inspection |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 3. |
Disconnect the connector from the power window switch module.
|
| 4. |
Check for continuity between the terminals in each switch position according
to the table.
[Driver Auto]
[All Auto]
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim panel.
(Refer to Body - "Front Door Trim")
|
| 3. |
Disconnect the connector (A) from the switch.
|
| 4. |
Check for continuity between the terminals in each switch position according
to the table. If the continuity condition is not normal, replace the
switch.
[Manual]
[Auto]
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear door trim panel.
(Refer to Body - "Rear Door Trim")
|
| 3. |
Disconnect the connector (A) from the switch.
|
| 4. |
Check for continuity between the terminals in each switch position according
to the table. If the continuity condition is not normal, replace the
switch.
[Manual]
[Auto]
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 3. |
Remove the power window bezzel assembl (A) after loosening the mounting
screws.
|
| 4. |
Remove the power window switch assembly (A) after loosening the mounting
screws (4EA).
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 3. |
Remove the power window switch assembly (A) after loosening the mounting
screws.
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
| 3. |
Remove the power window switch assembly (A) after loosening the mounting
screws.
|
| 4. |
Check for continuity between the terminals in each switch position according
to the table. If the continuity condition is not normal, replace the
switch.
|
| Installation |
| 1. |
Install the power window switch assembly.
|
| 2. |
Install the front door trim after connect the connector.
|
| 1. |
Install the power window switch assembly.
|
| 2. |
Install the front door trim after connect the connector.
|
| 1. |
Install the power window switch assembly.
|
| 2. |
Install the rear door trim after connect the connector.
|
Power Window Switch Schematic diagrams
Power Window Relay Repair procedures