Kia Carens: Panorama Sunroof / Panorama Sunroof Motor Repair procedures

Kia Carens RP (2013-2018) Service Manual / Body Electrical System / Panorama Sunroof / Panorama Sunroof Motor Repair procedures

Inspection

1.	Disconnect the negative (-) battery terminal.

2.	Remove the roof trim assembly. (Refer to Body - "Roof trim assembly")

3.	Disonnect the connector (A).

4.	Remove the panoramaroof motor (B) after loosening 3 bolts.

Ground the terminals as below table, and check that the panoramaroof unit operates.

–	When inspecting the panoramaroof motor operation, panoramaroof motor and roller blind motor always should be connected.

Make these input tests at the connector. If any test indicates a problem, find and correct the cause, then recheck the system. If all the input tests prove OK, the panoramaroof motor must be faulty; replace it.

Terminal	Test condition	Test: Desired result
12	IG2 ON	Check for voltage to ground: There should be battery voltage.
3	Under all conditions	Check for continuity to ground: There should be continuity.
1	Under all conditions	Check for voltage to ground: There should be battery voltage.

Panorama Sunroof Switch Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the ...

Roller Blind Motor Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof trim ...

Other information:

Kia Carens RP (2013-2018) Owners Manual: Low tire pressure telltale

When the tire pressure monitoring system warning indicators are illuminated, one or more of your tires is significantly under-inflated. If the telltale illuminates, immediately reduce your speed, avoid hard cornering and anticipate increased stopping distances. You should stop and check your tire ...

Kia Carens RP (2013-2018) Service Manual: Front Seat Belt Buckle Repair procedures

Replacement 1. Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly") 2. Disconnect the front seat belt buckle connector wiring (A). 3. After loosening the ...